Product Manual

EN
TEC29 EV AUS Operating the generator
31
10.6 Operating two generators in parallel (optional)
I
You can independently turn each generator on and off. If the load is more than
2600 W, you can start both generators in parallel.
If the parallel cable is connected, each control panel shows the status of the parallel
system:
• “GEN ON” (fig. 4 10, page 11): Stand alone operation of one generator.
The second generator is completely turned off (the control panel is switched off
and/or the maintenance switch is turned off). In this case the running generator
cannot recognize the second generator.
• “–GEN ON” (fig. 4 10, page 11): Stand alone operation of one generator.
The second generator is in stand-by and can be started.
• “=GEN ON” (fig. 4 10, page 11): Both generators are running in parallel.
The power output (fig. 4 7, page 11) shown is the power generated by each
single generator. The total power output is the sum of both values.
NOTE
The maximum allowed load for the parallel system is 4800 W.
TEC29EV-IO-AUS.book Seite 31 Montag, 6. März 2017 8:37 20