Product Manual

EN
TEC29 EV AUS Troubleshooting
43
➤ Measure the distance between the electrodes with a thickness gauge (fig. n,
page 42). It must be 0.7 – 0.8 mm and can be corrected by bending the elec-
trode if necessary.
➤ Check whether the spark plug seal is intact.
➤ If so, screw in the spark plugs by hand to avoid damaging the thread.
➤ Tighten the spark plugs using a spark plug wrench so that the washer is pressed
together.
➤ Finish the maintenance work, see chapter “Finishing maintenance work” on
page 39.
13 Troubleshooting
Fault Cause Remedy
The digital control
panel does not
come on when the
on/off switch is
pressed.
Starter battery is flat (9 V). ➤ Charge the starter battery.
Power cable is disconnected or the plug
is removed.
➤ Contact an authorised workshop.
Generator earth cable is disconnected or
the fuse (if available) is blown.
The starter does
not work when the
start button is
pressed.
Starter battery is flat. ➤ Charge the starter battery.
The main switch is at “0”. ➤ Set the main switch to “I” or “1”.
Starter shaft is dirty. ➤ Clean the starter shaft.
Too much oil in the engine. ➤ Drain the oil.
Inverter is damaged. ➤ Contact an authorised workshop.
Power cable is disconnected or the plug
is removed.
Generator earth cable is disconnected or
the fuse (if available) is blown.
Starter is not receiving any power.
TEC29EV-IO-AUS.book Seite 43 Montag, 6. März 2017 8:37 20