User manual

5. TO USE A FREEZER

Fig. 30.

Allow the ILR to run. The temperature inside the

cabinet will be indicated on the thermometer on the

front side. Observe the temperature from time to time

(fig.30)

Initially the temperature inside the ILR will be similar to,

or slightly below, the room temperature. It should

decrease slowly and should remain steady within a

smal! range, after 1-3 days, depending upon different

conditions.

When the ILR is functioning as `Freezer', the

thermostat on the front panel has no function and no

control over the cabinet temperature. The control is

now shifted to another thermostat (freezer-thermostat)

which is located behind the function selector switch in

the compressor compartment. This thermostat has

been factory preset on =18°C. However, if the cabinet

temperature does not reach the required low level of

2-3 days, the freezer-thermostat setting can be

increased to a higher setting by turning its knob

clockwise.

To get access to the freezer-thermostat, the side

cover of the compressor compartment is to be

removed as described earlier on page 12 (actions 1

and 2).

CAUTIONS:

Power supply must be disconnected before

removing of the compressor compartment cover as

there are live parts within.

Touching these parts may be fatal if power is not

disconnected.