Portable Generator User Manual

TEC 40D
18
user’s manual
GB
SOLUTION
The emergency stop switch is not to ON The starter is not powered up The electrical cables are broken The generator earth wire (or fuse) is broken No fuel Check the load supplied No fuel received from injectors The air filter is dirty The Air intakes are obstructed Inverter is damaged Load over 3.5 kW Low battery charge The starter shaft is dirty Electric pump unfed/out of order Too much oil in the engine
CAUSE
By operating the main switch, the
panel does not switch on
By pushing the start button, the
generator does not start (the
starting motor does not run)
The starting motor runs but the
generator does not start
The generator tends to stall
The generator runs but it does not
produce current
The generator starts, then stops and
display “generator alert!” message
The produced current oscillates
3.1 Faults, causes and solutions
Operations to be carried
out by the user
Operations to be carried
out by qualified technicians
Troubleshooting, maintenance, recycling 3