User manual

TEC 29 12
user’s manual
GB
2.1 Instructions for fixing the generator
Warning
Make sure there is enough space around the casing of the generator for cooling, leaving at least 20 mm of free space between the casing and the
surrounding walls or parts. If the air intake of the generator remains behind a wheel of the vehicle, make sure that in the case of rain the wheel will
not spray water onto or into the generator taking preventing measures if necessary (ex. antispray guards).
The brackets supplied make it possible to install the generator both externally (Type A) and internally (Type B).
“Type A ” assembly (external installation) offers the following advantages: less internal space occupied, rapid installation, easy access for the
routine and extraordinary maintenance. For the “Type A” installation you will have to use the “omega brackets” supplied to guarantee that the unit
will be correctly fitted. If you decide to install the generator with the “Type B” installation (internal installation), you will have to prepare a sealed
cabinet inside the vehicle (which can be further sound-proofed), being careful to respect the air space of 20mm between the generator casing and
the surrounding parts, with the exhaust and air intake holes in the floor and door. The air intake must be at least 240 cm
2
. Furthermore you should
also install a fire-proof rubber gasket of at least 5mm between the floor and the base of the generator (available as accessory Ref. AG128).
2 Installation instructions
360
2
9
0
5
8
0
4
8
0
5
4
8
1
60
385
9
9
10.5
3
6
0
3
1
0
1
0
4
5
4
8
2
9
5
3
0
2
0
3
5
2
3
Air intake
Type A
Type B
Air intake
hole
Cabinet
Gasket
Drain
hole
Omega bracket