User manual

TEC 29 18
user’s manual
GB
3.1 Faults, causes and solutions
3 Troubleshooting, maintenance, recycling
Operations to be carried out by the user
Operations to be carried out by qualified
technicians
SOLUTION
The emergency stop switch is not to on The starter is not powered up The electrical cables are broken The generator earth wire is broken No fuel The choke is not available Thethrottlevalvleisblocked No current to the spark plug No petrol to the carburettor The air filter is dirty The Air intakes are obstructed The inverter is damaged Load over 2.6 kW Low battery charge The starter shaft is dirty The stepper motor is down or disconnected Too much oil in the engine
CAUSE
By operating the main switch, the panel
does not switch on
By pushing the start button,
the generator does not start (the starting
motor does not run)
The starting motor runs but the generator
does not start
The generator tends to stall
The generator runs but it does not produce
current
The generator starts, then stops and
display “generator allert” message
The produced current oscillates