User's Guide

Revision 19.1
SOLO7 Transmitter User Guide
Copyright © 2013 Domo Tactical Communications (DTC) Limited. All rights reserved.
Commercial in Confidence
Page 3-5
3. Controls, Connections and Indicators
3.1 Front Panel
No Item Used for...
1 SMA receptacle
(socket).
Connect an antenna to the SMA receptacle on the top panel of the
transmitter unit.
Peak antenna gain must be no greater than 14.5dBi. DTC recommends
the use of 2dBi antenna accessory, see Section 2.3 .
CAUTION: Do not over tighten the antenna – hand tight only!
2 Config button The config button can be operated with a blunt but pointed tool. A
ballpoint pen is ideal for this purpose.
When you want to confirm the config that the SOL7TX is set to, press
the config button once. The LEDs will flash accordingly.
When you want to change the config, press and hold the config button
until the red LED lights. The config will change incrementally, and the
LEDs will flash accordingly.
Note: See the label on the top panel for the LED config sequence, refer
to Section 2.5 .
3 Red/green dual
colour LED
The red LED is used to indicate the video input status:
No light = video locked or off.
Flash = video error.
The green LED is used to indicate the RF input status:
No light = RF off
Solid ON = RF on
Note: The red/green LED is also used to indicate the config number that
the SOL7TX is set to. See Config button above.