User's Guide

Revision 19.1
SOLO7 Transmitter User Guide
Copyright © 2013 Domo Tactical Communications (DTC) Limited. All rights reserved.
Commercial in Confidence
Page 5-21
5.5.2 Modulation Settings
Name Options Notes
Modulation Output Off or On Switches RF on or off.
Repeats the action of the RF button on the Unit Status panel
on the primary window.
Output Frequency In-band
The frequency in megahertz (MHz) that you want to use for
this preset. This is between 2452.5-2481.0MHz.
If you try to input a frequency that is out of range, the radio
will tune the nearest available frequency automatically.
The transmitter frequency can be set in step sizes of 125kHz.
Output Power 10mW
50mW
100mW
200mW
500mW
1W
2W
5W
Choose the power output you want to use for your
transmission up to 100mW. Power levels above this are not
applicable to SOL7TX.
Lower power outputs will run cooler.
CAUTION: The combination of 100mW output power and high
linearity must only be used with additional cooling, either
extra heat sinking or a fan.
Output Attenuation 0 to 31.75dB 0 to 31.75dB of attenuation can be applied to the output of
the transmitter.
Linearity mode
Low power
High linearity
Ultra high lin
High linearity mode improves shoulder performance by
several dB at the expense of power consumption. Often used
when working with amplifiers which need excellent shoulder
performance to operate, or for improved adjacent channel
performance.
See Section 6.1 for more detail.
CAUTION: The combination of 100mW output power and high
linearity must only be used with additional cooling, either
extra heat sinking or a fan.