User's Guide
Table Of Contents
- SOLO7 Transmitter User Guide
- 0. Preface
- 1. Product Overview
- 2. Product Package
- 3. Controls, Connections and Indicators
- 4. Getting Started
- 5. Domo Device Controller Operation
- 6. Advanced Operation
- 7. Appendix A – Reference Material
- 8. Appendix B – After-Sales Support
- 9. Appendix C – Safety and Maintenance
- 10. Appendix D – Glossary
Revision 19.1
SOLO7 Transmitter User Guide
Copyright © 2013 Domo Tactical Communications (DTC) Limited. All rights reserved.
Commercial in Confidence
Page 5-29
5.7.2 Video Settings
Note: The video encoder settings can be configured for optimum performance using the sliders on the
Control Application primary window, see
Section 4.3
or refer to
Section 7.3
for guideline settings.
Name Options Notes
Video Source Off
Composite 1
Composite 2
S-Video
Select the video source input.
Video Source Format Automatic
PAL
NTSC
NTSC NP
Select the video format that matches the camera you
are using.
Alternatively, the Automatic setting will determine
the video source.
Power up standard in Automatic mode defaults to
PAL. This can be changed by setting the input to
NTSC NP for example and then back to Automatic.
Video Encoder
MPEG4 ASP
MPEG4 H.264
MPEG4 ASP may be required backward compatibility
with older receivers.
MPEG4 H.264 generally provides improved picture
quality over ASP.
Encoder Mode Standard Delay
Low Delay
Ultra Low Delay
Standard Delay mode provides higher picture quality
at the expense of delay. Should be used with long
range modulation parameters.
Ultra Low Delay mode provides exceptionally low
delay at the expense of picture quality. Short range
modulation parameters will generally be required.