User's Guide
Table Of Contents
- SOLO7 Transmitter User Guide
- 0. Preface
- 1. Product Overview
- 2. Product Package
- 3. Controls, Connections and Indicators
- 4. Getting Started
- 5. Domo Device Controller Operation
- 6. Advanced Operation
- 7. Appendix A – Reference Material
- 8. Appendix B – After-Sales Support
- 9. Appendix C – Safety and Maintenance
- 10. Appendix D – Glossary
Revision 19.1
SOLO7 Transmitter User Guide
Copyright © 2013 Domo Tactical Communications (DTC) Limited. All rights reserved.
Commercial in Confidence
Page 6-37
6.1.3 About DC Power Use
SOLO7 Transmitter is very power efficient. In earlier models of transmitter, if you switched from high to low
RF power, the same DC power level would be used although the RF signal was attenuated.
In these newer transmitters, when you select lower RF powers the DC power level is dropped too, using just
the power needed to achieve the RF power required.
This stepping down of the DC power level applies to both Low Power Mode and High Linearity Mode.