Instructions for use

DO-261A

To activate sleep settings, press on sleep function button making sure appliance

is already set to the Cooling (down) Mode.

The top ventilator will switch automatically to low speed. After one hour the selected

temperature will increase by 1°C, and by 2°C after two hours. After six hours the

appliance will automatically switch off.

The control panel has a memory function that stores the mode last used. This memory

function remains active for as long as the appliance remains on standby (with the

exception of mode).

REMOTE CONTROL

button. For switching the appliance on and off.

2. button. Use this to select the desired function.

3. button. Select the desired ventilation speed

4. ▲ button. For increasing the temperature or adjusting

timer.

5.▼ button. For decreasing the temperature or adjusting

timer.

6. button. Activate of deactivate the sleep setting.

7. button. Activate or deactivate the automatic timer

function.

Placing Battery in the Remote Control

Slide the cover to open at back. Place two AA-batteries in the correct position in the

remote control. Slide the cover back into place. Make

sure the positive and negative markers correspond with

the markings on the remote control.

Do not use old and new batteries together. If you are not

going to use the remote control for an extended period

remove the batteries.Always dispose of used batteries in

a responsible manner, give them to a processing rm or

waste processing company. Point the remote control towards the infrared receptor in

your appliance. The remote control has a maximum range of 7 metres.

INSTALLING THE AIR OUTLET PIPE

1. Air pipe

2. Appliance connection adaptor

3. Wall tting for outlet pipe

4. Remote control

5. Water collection container

6. Water discharge pipe