Instructions for use

DO-261A
MAINTENANCE
Switch the appliance off before you remove the plug from the socket. Clean the
appliance with a soft, dry cloth. If the appliance is very dirty use lukewarm water
(colder than 40°C) to clean it. Never use volatile or abrasive cleaning products. Never
spray water onto the outside casing.
Cleaning the Air Filter
Switch the appliance off and unscrew the air lter’s locking system
by a half turn upwards. This is located at the back of the appliance.
To remove the air lter, press upwards. Wash the lter in a mixture
of soap and lukewarm water and allow it to dry carefully before putting it back into
place. If the appliance is located/placed in a very dusty place it should be cleaned
every two weeks.
Not Using the Appliance for an Extended Period
Remove both rubber plugs from the drainage openings to remove remaining water.
Allow the ventilator to run own its own for another day in order to make sure the
appliance is thoroughly dry inside and to prevent mould forming.
Switch the appliance off and remove the plug from the electric socket. Remove the
batteries from the remote control. Clean the air lter, dry it and then put it back.
Disconnect the air pipe and carefully close the opening.
ERROR MESSAGES
The appliance does not click on The appliance is not plugged in properly to the
socket.
The fuse in the fuse box is blown
The batteries in the remote control have run out
Always wait for steeds 3 minutes before you
restart the appliance
The appliance works only for a
short while
The selected temperature is approaching the room
temperature
Select a lower temperature or wait until the
appliance automatically switches on again
The air outlet is blocked
32