Instructions
33
DO91606W-DO91608W
www.domo-elektro.be
EN
PARTS
1. Control panel
2. Large wooden racks
3. Small wooden rack
4. Ventilation openings
5. Door
6. Handle
7. Levelling feet
INSTALLATION
· Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and the
· Use two or more people to move and install the appliance. Failure to do so can result in back or other
injury.
· Make sure that the air can circulate around the appliance. Therefore, leave a free space of at least 5 cm
between the appliance and any other object.
·
· To ensure proper ventilation for your appliance, the front of the unit must be completely
unobstructed. Choose a well-ventilated area with temperatures above 16°C (60°F) and below 32°C
(90°F). This unit must be installed in an area protected from the elements, such as wind, rain, water
spray or drips.
· This cooling appliance is designed to be for free-standing or built-in installation.
·
·
the coating of the appliance and the proximity of heat sources may cause an increase of the energy
consumption. Extreme temperatures may also cause malfunctioning of the appliance.
·
evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the voltage stated on the rating
appliance.
· The cord should not be exposed or left hanging loose to prevent possible accidents.
· After installation, leave the refrigerator for 24 hours before turning it on. This way the refrigerant can
settle.
· Before connecting the appliance to the power net, leave it standing upright for about 2 hours. This
reduces the risk of any malfunctioning of the cooling system due to transportation.
· Allow the appliance to run empty for 8 hours so the compartment can cool to the appropriate
temperature.
· One can level the appliance using adjustable legs. The adjustable legs can be adjusted by screwing
them in or out of the appliance.