Portable Multi Steamer USER MANUAL MODEL: DSC21
IMPORTANT SAFEGUARDS When using an electric appliance, basic precautions should always be followed: READ ALL INSTRUCTIONS BEFORE USING THIS STEAMER WARNING DANGER OF SCALDING CAUTION - To reduce the risk of fire, electric shock, or injury: ! To provide continued protection against risk of electric shock connect to properly grounded outlets only. ! Check that the main voltage corresponds to the voltage indicated on the rating label. ! This product is designed for domestic use only. ! Do not use outdoors.
KEY FEATURES 1. Handle 2. Safety Filler Cap 3. Locking Trigger Button 4. Trigger Release 5. Deluxe Hose 6. Steam Gun 7. Steam Trigger 8. Extension Tubes (2pcs) 9. Connector 10. Deluxe Floor Brush 11. Floor cotton cloth (2pcs) 12. Concentrator tool 13. Fabric Brush 14. Glass Squeegee 15. Round Brush (2pcs) 16. Funnel 17. Refill Cup(500ml) 18.Fabric Brush Pad 19. Shoulder Strap 20. Shoulder Strap Hook 21. Steam unit 22.
FILLING THE STEAM CLEANER WITH WATER WARNING! THERE IS A DANGER OF SCALDING. YOU MUST NEVER ATTEMPT TO REMOVE THE SAFETY CAP WHILE THE STEAM CLEANER IS SWITCHED ON OR UNDER PRESSURE. THE TOOLS AND HOSE WILL GET HOT DURING USE. ALLOW THE TOOLS TO COOL DOWN BEFORE CHANGING THEM WHILE THE STEAM CLEANER IS BEING USED. The steam cleaner tank has a capacity of 650ml. Check that the steam cleaner is disconnected from the mains supply. Press the Locking Trigger Button until any pressure has been released.
SWITCHING ON AND OFF Mains Power Plug the 3-pin mains plug into the mains supply. The Indicator light will come on to show that the steamer is heating the water. Steam will be available after approximately 3 to 4 minutes. The steamer will provide continuous hot steam for approximately 20 minutes for each fill of the tank. (650ml). To switch Off, unplug the power cable, the Indicator Light will go out. NOTE: DO NOT LEAVE THE STEAM CLEANER UNATTENDED DURING THE HEATING-UP PERIOD.
WARNING! THE TOOLS, EXTENSION TUBES AND THE HOSE WILL GET HOT DURING USE. ALLOW THE TOOLS TO COOL DOWN BEFORE REMOVING THEM WHILE THE STEAM CLEANER IS BEING USED. FITTING THE ACCESSORY TOOLS - CONTINUED The tools can be fitted in a variety of different sequences. See below. Always make sure that the tool is locked securely in place before using the steamer. The glass squeegee must be used in conjunction with the fabric brush. The round brushes can only be used in conjunction with the concentrator tool.
FITTING THE ACCESSORY TOOLS - CONTINUED The floor brush cotton cloth can be fitted to the floor brush if a softer surface is required for cleaning. To fit a floor brush cotton cloth, first press and hold down the cotton cloth retaining clip on one side of the floor brush. Position one side of the floor brush cotton cloth under the retaining clip. Release the retaining clip.
FITTING THE ACCESSORY TOOLS CONTINUED The window cleaning squeegee can be attached to the fabric brush. Remove the fabric brush pad, if fitted. Locate the two lugs on the squeegee in the slots on the rear of the fabric brush. Push the squeegee upwards until it clicks into place over the clip on the front of the fabric brush. The round brush can be fitted to the concentrator tool for cleaning in corners and other areas with limited access.
USING THE STEAM CLEANER WARNING! DO NOT USE THIS STEAM CLEANER ON ANY APPLIANCE THAT CONTAINS ELECTRICAL COMPONENTS, (SUCH AS THE INTERIOR OF OVENS), AND IS NORMALLY CONNECTED TO A MAINS OR BATTERY POWER SUPPLY. NEVER TURN THE HAND STEAMER ON ITS SIDE WHEN STEAM CLEANING, OR DIRECT STEAM AT ANY PERSON, PET OR PLANT. CAUTION! DO NOT USE ON DRAYLON, SOFT PLASTICS, UNSEALED WOOD AND COLD GLASS.
Refilling the steam cleaner while cleaning Should the need arise to refill the steam cleaner with water while cleaning, unplug the power cable from the mains supply socket. Press the steam release trigger until all pressure has been released. WARNING! ALTHOUGH THE STEAM PRESSURE IN THE STEAM CLEANER HAS BEEN RELEASED, THE STEAM CLEANER STILL CONTAINS VERY HOT WATER. DO NOT ATTEMPT TO REMOVE THE SAFETY CAP UNTIL THE STEAM CLEANER HAS COOLED DOWN.
MAINTENANCE There are no user servicable parts inside the steam cleaner. Cleaning WARNING! THE STEAM CLEANER MUST BE UNPLUGGED FROM THE MAINS POWER SUPPLY AND ALLOWED TO COOL DOWN BEFORE ALL CLEANING AND MAINTENANCE TASKS. ALWAYS UNSCREW THE SAFETY CAP VERY CAREFULLY TO ENSURE THERE IS NO PRESSURE INSIDE UNIT. WAIT AT LEAST 5 MINUTES FOR THE STEAM CLEANER TO COOL, THEN CAREFULLY START TO UNSCREW THE SAFETY CAP. IF YOU HEAR STEAM ESCAPING, STOP AND WAIT UNTIL THE HISSING SOUND STOPS.
TROUBLESHOOTING GUIDE Below is a chart detailing the most common problems, their causes and solutions. Prior to troubleshooting, isolate the unit by removing the cord from the power socket. PROBLEM No steam CAUSE SOLUTION The steamer is not Plug the power cable and on. make sure the Indicator light is on. Water tank is empty. No steam, but Condensation water formed inside hose. Puffs of steam during refill Refill the instructed.
After Sales Service. Warranty: This product is warranted to the original user for 12 months from date of purchase free from manufacturing defect at time of purchase. The product is intended for domestic use. Please keep your receipt or other evidence of purchase showing date of purchase, as this must be produced in the event of a claim. To claim under this warranty, or for other repair or assistance with this product, please contact Domotec Customer Service Department by phoning 01844 698516.
