Installation Manual

!
HOW TO MEASURE FOR A KICK PLATE

MEASURE YOUR DOOR:
1. MEASURE THE WIDTH OF THE DOOR!
2. SUBTRACT 2” FROM THE WIDTH OF THE DOOR
FOR STOPS AND WEATHER STRIPPING!
3. MEASURE FROM THE BOTTOM OF THE DOOR TO
THE BOTTOM OF THE FIRST PANEL. THEN
SUBTRACT 1” FROM THE HEIGHT (IF YOUR DOOR
IS FLAT AND DOES NOT HAVE A PANEL, CHOOSE
DESIRED HEIGHT.) !
4. IF THE BOTTOM OF THE DOOR HAS WEATHER
STRIPPING, DO NOT INCLUDE THAT IN THE HEIGHT. !
EXAMPLE: !
A 36” WIDE DOOR WITH A 9” TALL BOTTOM RAIL
WOULD USE AN 8” X 34” KICK PLATE. !
HOW TO INSTALL:
1. CENTER THE KICK PLATE ON THE DOOR!
2. USE PAINTERS TAPE TO HOLD THE KICK PLATE IN
PLACE.!
3. DRILL PILOT HOLES; ONLY DRILL ONE HOLE AT A
TIME. THEN INSTALL THE SCREW. !
4. INSTALL SCREWS BY STARTING IN THE MIDDLE OF
THE KICK PLATE.!
5. FOR BEST RESULTS INSTALL ONE SCREW AT THE
TOP, THEN ONE ON THE BOTTOM AND CONTINUE
USING THE SAME PATTERN. ALWAYS START FROM
THE MIDDLE AND WORK OUT. !
6. REMOVE PLASTIC PROTECTIVE FILM AFTER KICK
PLATE IS INSTALLED.
###!
# # # DOOR WIDTH !
# # DOOR HEIGHT