User's Manual

AC OPERATION
1. Connect the AC Power Adaptor to a wall outlet with AC120V/60Hz power supply.
 Time Setting
1、In standby mode, press CLK/MEM button to enter into clock setting mode, again press
CLK/MEM button for 2-3 seconds, time digital blinking, then press HR/MIN buttons to set
the time, and press CLK/MEM button to confirm.
 Alarm Setting
1、In standby mode, press VOL+/ALM1 button, the “ALM1” indicator and “time digital”
begin blinking, then press HR button to adjust the hour and MIN button to adjust the
minute, and press VOL+/ALM1 button to confirm. Alarm rings when time’s up.
2、In standby mode, press VOL+/ALM1 to choose among BUZZER→RADIO→ALM OFF.
The unit will quit setting mode automatically without pressing the VOL+/ALM1 button in 5
seconds.
3、During alarm ringing, press SNOOZE button to close the alarm for 9 minutes, and
alarm rings later again. You can press VOL+/ALM1 button or ALM OFF button to turn off
the alarm. When alarm rings, the related icon will blinking display.
4、To set ALM2 please refer to ALM1 setting method.
Alarm Check
1.In standby mode, press and hold ALM1/ALM2 1-2 seconds to check the Alarm(will disp
lay the alarm time and alarm status)
2.Under the state of power-on, you can check the alarm status without pressing any butt
ons(will only display the alarm status, and no alarm time displayed)
 Snooze Setting
1、Under alarm ringing, press SNOOZE button to enter into snooze function, the alarm
will ring after 9 minutes, and it will last 60 minutes. You can press ALM OFF button to turn
off the alarm.
 Radio Mode
1、Press the POWER button to turn the unit on, and “FM” will be the default function,
press again to convert to “AM” function, the LED will display the corresponding radio
frequency.
2、Manually Searching: press HR/MIN button to search the stations by manually tune the
frequency.
3、Automatically Searching: Long press the HR/MIN button to search the stations by
automatically tune the frequency.
4、Radio Storing: select the radio frequency that you want to save, then press CLK/MEM
button for 2-3 seconds, and “P01” on the LED display will blinking, press HR/MIN to
choose the preset location, short press CLK/MEM to confirm.
5、Memory Obtaining: Press MEM button to load the preset stations, and it will display
P01、P02, then again press MEM button to the next preset station, and the frequency will
be displayed in 3 seconds. Without pressing any buttons, it will quit and display the clock
in 5 seconds.