User's Manual

SETUP
27
AutoPlay
With Auto Play turn ON (the factory default setting), the VCR automatically
starts playback when you insert a tape with its safety tab removed.
1 Use […/†] to select ‘AutoPlay‘.
2 Press [√] to go to the second level.
3 Use […/†] to set the AutoPlay Status to On or Off .
4 Press [ENTER] to confirm.
YourDVD
???????
1 Use […/†] to select ‘YourDVD‘.
2 Press [√] to go to the second level.
3 Use […/†] to set the YourDVD Status to On or Off .
4 Press [ENTER] to confirm.
• Some options cannot be reset, including Parental Controls, Password, and Country Code.
• After Restoring Defaults the unit reboots automatically and the Installation menu
appears. You must set the country, language, channel, and clock settings again.
If you wish, you can reset the DVD Recorder+VCR to its original factory
settings.
1 Press [SETUP].
2 Use [œ/√] to select ‘Restore Defaults Page ‘.
3 Press [ENTER].
4 The Initialize menu will appear. Use the […†œ √] buttons to select
‘OK‘ and press [ENTER].
System Information
System Information helps service personnel identify key firmware
information about your DVD Recorder+VCR in case service is required.
Restore Defaults
Initial Setup
- - Preference Page - -
Video
Audio
Parental Ctrl
Auto Clock
VCR
AutoPlay • Off
YourDVD On
Choose OK Exit
ENTER SETUP
œ √
…
†
- - Preference Page - -
Video
Audio
Parental Ctrl
Auto Clock
VCR
AutoPlay
YourDVD • Off
On
Choose OK Exit
ENTER SETUP
œ √
…
†
- - System Info Page - -
Version 0000BBBBTT
Main Build VER0049.04
Micom Software 1.0.1
Loader Version AA0600 A100
Choose OK Exit
ENTER SETUP
œ √
…
†
- - Restore Defaults Page - -
If you select this function all settings
will be removed and the product will be
set into initial (factory) mode.
Choose OK Exit
ENTER SETUP
œ √
…
†
Your DVD
Audio Language X
Subtitle Language V
Surround Mode X
OK
Restore Defaults
Are you sure you want to restore
default settings?
OK Cancel
DF-Q74D2N-LS(GB)_ US A 05.1.25 6:4 AM 페이지27