User's Manual

15
NS-SH513 Bluetooth/CD Compact Shelf System
www.insigniaproducts.com
Programming and timing CD playback
To program CD playback:
1 Press
 (stop) while playing a CD, then press PROGRAM. The display
shows “PR 0100.”
2 Using the number buttons, enter the number of the song you want to
play first. For example, to select song 4 as the first song played in the
program, enter “0” then “4” for track 4. (Important note-you must enter
two digits for the song numbers.) After each song is entered, your
compact shelf system is automatically set up for you to enter the next
song. Continue programming until you have entered all the songs you
want to play.
3 When you finish programming, press PLAY/ENTER to confirm. Your
compact shelf system will play the songs by the programmed order.
4 To cancel the program, press
 (stop) once.
To set the playback from a specific time point:
• Press TIME once, the display screen shows “D_ _ _ _.” Enter the digits
to set the desired listening time from the beginning of the disc. For
example, If you want to start playback from time 35:05 (within the
total disc time), press TIME once, then enter digits 3, 5, 0, 5 on the
“D_ _ _ _” interface. The CD starts playing from 35:05.
• If you want to listen to the current track from a specific time point,
press TIME twice, the display screen shows “T_ _ _ _.” Enter the digits
to set the desired listening time of this track. For example, if you want
to start playback from time 03:05 (within the total current track time),
press TIME twice, then enter digits 0, 3, 0, 5 on the “T_ _ _ _”
interface, the CD starts playing the content of 03:05.
Note
Program CD playback is available only for standard music CDs,
not MP3 or WMA CDs.
Notes
While playing music from a USB device, you can only set the
playback time of the current track.
While playing music from an MP3 or WMA CD, you can only set
the playback time of the current track.
NS-SH513_15-0754_MAN_V3_ENG.fm Page 15 Thursday, August 13, 2015 1:32 PM