Specifications

2.机械性能
MECHANICAL
BEHAVIOR
按键工作的负荷力
Buttons force
按键高度
Buttons height
按键未按下的高度H＜3mm
/height h button unpressed
H＜3mm
按键按下起作用时的高度H1不
能低于上盖面 /height H1
shall not be lower than
the upper cover when the
button is pressed and the
RC is working
按键强度
Buttons strength
在按键平面中央垂直施加30N
的负荷力3 分钟
Apply 30N vertically in
the center of the buttons
plane for 3 minutes
按键无损坏，各功能正常
Buttons are not damaged, all
functions should be normal
按键的负荷寿命
Life of Buttons
以3-5次/秒的按压频率按键≥
20万次，不到位次数小于或等
于0.5％
Press the button with the
frequency of 3-5 times
/second more than 200,000
times, and the number of
times not in position is
less than or equal to 0.5%
按键无损坏，
各功能正常
Buttons are not damaged, all
functions should be normal
按键的复位
Reset button
分别在按键平面1/4 位置的左
端和右端及按键的左、右、前
、后侧面施加10N的力，按压
三分钟
Apply 10N force on the
left end and right end of
1/4 position of the button
plane and the left, right,
front and back side of the
button respectively, press
for 3 minutes
按键无损坏，各功能正常
Buttons are not damaged, all
functions should be normal
遥控器耐压强度
Remote control pressure
resistance
遥控器无损坏且功能正常
Remote control is not damaged
and all functions should be
normal
电源盖板插拔寿命
Power cover plug life
以2-3次／分钟插拔频率插拔
电源盖板不少于100次
Plug and cover the power
cover at a frequency of 2-
3 times/min not less than
100 times
无异常
Without exception
正常
正常
正常
正常
正常
正常
正常
0
5
2
.2
按键工作的负荷力，按键平面中
央垂直施加的最小负荷力
F=130g±20g；
Load force of key operation, in
key planeMinimum load force
applied vertically by the center
F=130g±40g；
遥控器整体的耐压强度，遥控
器装好电池,对其正面和底面
分别施加100N垂直力15 秒,
Remote control overall pressure
strength, remote controlInstall
the battery on the front
and bottom of the deviceApply
100N vertical force for 15
seconds,