User's Manual

Clock mode debugging parameters:
① Press and hold the time key time Set for 3
seconds to enter the clock setting mode. Press and
hold the time key briefly to set the time. Press and
hold again to change the number area.
② Short press to set the minutes. After adjusting
the hours and minutes correctly, wait for 5 seconds
or long press for 3 seconds to complete the time
setting.
Alarm mode adjustment parameters:
① Press and hold the alarm key Alarm Set for 3
seconds to enter the alarm setting mode;
② Short press the setting time, and long press again
to switch the digital area;
③ Short press Set Minutes, adjust the hours and
minutes correctly, wait for 5 seconds to complete the
alarm setting, and then the small alarm icon lights up.
Alarm cancellation:
Press and hold the Alarm set button for 3 times (3
seconds each time);
Precautions for alarm clock:
When in the 12 hour mode, adjust the alarm time
according to the PM AM icon
Time format operation:
Long press the 12/24H button to switch the 12/24
hour mode
The time is equipped with a 3V button battery. When
the input terminal is not connected to the power
supply, the button battery supplies power to the
clock chip (time is not displayed) to ensure that the
time is on time after power failure and reconnection.
Rules. These limits are designed to provide
reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures: – Reorient or relocate the receiving
antenna. – Increase the separation between the
equipment and receiver. – Connect the equipment
into an outlet on a circuit different from that to
which the receiver is
connected. – Consult the dealer or an experienced
radio/TV technician for help.
FCC Requirement
Any changes or modifications not expressly
approved by the party responsible for compliance
could
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause
undesired operation. Note: This equipment has been
tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC