Instruction Manual

Backlight led brightness adjustment
ZL+ZR+R3 and direction key up and down to adjust the light
intensity of the handle, a total of 5 gear, 1 gear 100%, 2 gear
75%, 3 gear 50%, 4 gear 25%, 5 gear off backlight.
The methods of operation are as follows:
1. Hold down the ZL+ ZR+ R3 key and then hold down the
direction key up to strengthe the brightness of LED. If in 2
gear, press the key up, then become 1 gear. (Note: when
you change to gear 1, you can't turn it up any more.)
2. Hold down the ZL+ZR+R3 key and then hold down the
direction key down, then the brightness of led decreases.
If you press the key down when you are in the second
gear, it becomes the third gear
.
(Note: annular and abxy
led are brightened and weakened at the same time. And
in turbo mode, the annular red led is weakened and
strengthened at the same time. )
(Note: When programmed, the motor and led are the
strongest by default, and both the motor and backlight
have memory function.)
2. Hold down the turbo key first and then hold down the
direction key down to weaken the vibration of the motor.
If in the second gear, press the key down, it will become
3 gears ,each shift, the motor should also vibrate for 1
second,if adjusted to 3 gears, then the motor is 50%
vibration intensity vibration for 1 second.
-6- V:0.1 june 26,2019