Installation Instructions

FCC ID:2AG68TWS-860X
NOTE: This equipment has been tested and found to comply with the limits
for aClass B digital device, pursuant to part 15 of the FCC Rules. These limits
aredesigned to provide reasonable protection against harmful interference
in aresidential installation. This equipment generates uses and can radiate
radiofrequency energy and, if not installed and used in accordance with the
instructions,may cause harmful interference to radio communications.
However, there is noguarantee that interference will not occur in a particular
installation. If thisequipment does cause harmful interference to radio or
television reception, whichcan be determined by turning the equipment off
and on, the user is encouraged totry to correct the interference by one or
more of the following measures:- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.-Connect the
equipment into an outlet on a circuit different from that to which thereceiver
is connected.-Consult the dealer or an experienced radio/TV technician for
helpChanges or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:(1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

Summary of content (1 pages)