Safety Instructions

Cleaning and Maintenance

Switch the product off before cleaning.

Do not immerse the electrical parts of the product in water or other liquids.

Never hold the product under running water.

Cleaning

• Clean the battery contacts and also those of the product prior to battery installation.

• To clean, wipe with a soft, slightly moist cloth.

• Dry the product after cleaning.

• Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp utensils to

clean the product.

Maintenance

• Store in a cool and dry place away from children and pets, ideally in original packaging.

• Avoid any vibrations and shocks.

FCC Compliance Statement

1. This device complies with Part 15 of the FCC rules. Operation is subject to the following two

conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

2. Changes or modiﬁcations not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

FCC Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

NOTICE