User's Manual

② Put the solar wire across the waterproof tower case, and then insert the RJ45 into the "RAIN" 623K
hole of the transmitter;
③ Insert a M3 screw nut into the top nut slot of the waterproof tower case, then insert the solar
component into the top of the waterproof tower case, establish them with a PM3.0*8mm screw (Note:
insert the screw from the screw nut side of the solar component):
8.Suit the assembled waterproof tower case onto the assembled transmitter, and then suit the wires onto
the slots of the transmitter holder
9.Suit four green plastic screw nuts into the base, and then establish the base and ground with four
KA4.0*40mm screws：