Users Manual

oth-AB202 Mannual

Power on:

Press and hold the button for 2 seconds to power on, the green indicator light stays on for 3 seconds

and then enters the pairing state, the pairing state green indicator flashes for 1 second/time.

Pairing connection:

Turn on the device and enter the pairing state, use the Bluetooth device to search for the Bluetooth

name "SEAJIC", and click to connect.

Taking pictures/videos:

After the mobile phone enters the camera interface, short press the button to take a picture; after the

mobile phone enters the video recording interface, short press the button to take a video.

Power off： In the power-on and sleep state, press and hold the camera button for 3 seconds to turn off

the power, and the indicator light will turn off.

Charging：During the charging process, the red indicator light is always on, and

automatically turns off when fully charged. The charging current is 50MA.

1 Automatic shutdown after charging:

2 Low voltage indication：When the battery is low (less than or equal to 3.4V),

the red indicator light will automatically start flashing until it starts charging.

3 low power shutdown：When the battery voltage is lower than 3.0V, the remote

control automatically shuts down.

Button

MICRO USB

connector

PAGE 1
oth-AB202 Mannual Button MICRO USB connector Power on: Press and hold the button for 2 seconds to power on, the green indicator light stays on for 3 seconds and then enters the pairing state, the pairing state green indicator flashes for 1 second/time. Pairing connection: Turn on the device and enter the pairing state, use the Bluetooth device to search for the Bluetooth name "SEAJIC", and click to connect.
PAGE 2
Electrical parameters Power on current pairing current stand-by current Working current ＜18mA 0.5mA – 5mA 0.5mA–1.5mA 0.5mA – 2.5mA Power off current 小于 5uA momentary peak pairing status connection without working When pressing the key continuously Power off status Main configuration: Bluetooth chip TLSR8232 crystal oscillator 24MHZ,3.2X2.5mm EEPROMM built-in Button 5*5*1.
PAGE 3
Safety precautions: This product contains a built-in battery. It is not suitable to expose the product to strong sunlight or fire or Water spray . Do not place the device in an environment where the temperature is too high (more than 50 degrees Celsius) because This can cause serious damage to the equipment. FCC Regulatory Compliance This device complies with Part 15 of the FCC Rules.