User Manual

6.Steps to Drive Robstep M2
You should pay attention to related safety notes during using Robstep M2. Thus, you must fully understand all notes in this
manual before driving, and it is very important to understand these safety notes before using.
◆ Before using, please make sure Robstep M2 is assembled, and charge the battery continuously for more than 4 hours. For
installation of specific parts and charge of the battery, please see this manual.
◆ Before driving, you should fully know the driving environment.
◆ Please wear a safety helmet and protective clothing before driving Robstep M2.
◆ Please do not wear sharp objects to avoid injury during driving.
◆ Robstep M2 is a traveling tool for one person, and only one person can stand on the transporter body during using.
◆ When you practice driving, please do it on a spacious and flat indoor or outdoor site with the area of at least 5m*5m.At the
same time, please make sure the site is safe and spacious, the ground is flat, and no car, pedestrian, pet, bicycle or other
obstacle interfere the practice.
◆ Please do not practice driving on wet and slippery ground.
6.1 Startup of Transporter Body
Description of startup steps
When you start Robstep M2 for the first time or did not use it
for a long time, please turn on the system power (for normal
startup, please ignore this step)
Then, use the remote controller to control accordingly
(for detailed functions, please refer to Chapter 3
Information about Remoter Controller for Robstep M2)
20
系统电源按钮
普通模式
开机键
新手模式
开机键
关机键
静音键
Startup
Key
Normal
Startup
Key
Beginner
Power Button
Power-off
Key
Mute Key