User Manual

7.Maintenance and Servicing of Robstep M2

◆ The user needs to perform routine maintenance of Robstep M2.This chapter mainly describes steps and important

prompts to service or maintain Robstep M2.

◆ Before performing the steps below, please make sure the power supply and the charging cable of Robstep M2 are

disconnected.When the transporter is powered on or the battery is charged, please do not perform the steps below.

WARNING

7.1 Handling Notes

Lift and put down Robstep M2 with proper skills, and follow the steps below:

◆ Make sure Robstep M2 is not connected with the charger and is powered off.

◆ Lift the transporter body with one hand, and grip the foot of the lever for the next grade of the handle with the other hand to

lift Robstep M2 for handling.Please do not use the casing of the transporter body as the bearing point for handling.You can

also use the rear rack of Robstep (a secondary handling part) to handle easily.

7.2 Maintenance

◆ Check tire components regularly. Shake the tires along the rotary direction by hand, and observe whether tire components

shakes. If they shake, please check the bots used to install the tire and screw tightly.

◆ Check the right and left tires for serious wear regularly. If the tires are worn, please contact the after-sale department to

change them.

◆ Please check the screws used to connect the handle and handle lever components together, and tightly screw if they are

loose.

◆ Every time before use, please check the locking part of the quick release for loosening, and check the lock spanner for

tightness and serious wear. You can try to shake the locked handle lever. If the handle lever shakes or loosens, please

check the locking part of the quick release for damage. If the locking part has no damage, you only need to lock the lock

spanner.