User's Manual

HOMEDEPOT.COM
Please contact 1-855-556-1852 for further assistance.
5
MOUNTING THE PUSH BUTTON
□ Remove the front cover from the base by following step 1.
□ Mount the push button base to a clean wall or door jamb
with included #4 screws or mounting tape. If mounting with
screws, predrill a pilot hole through the push button base in
the desired location using a 5/64 in. drill bit.
□ Snap the push button cover onto the base by rst hooking
the tops together, then snapping the base on.
6
RESYNCING THE CHIME AND PUSH BUTTON
□ Press and hold the learning mode button on the chime until
you hear a ding sound. The chime is now reset and ready to
be resynced.
□ Follow step 3 to sync the chime and push button.
Safety Information
WARNING: Keep batteries out of reach of
children.
Specications
Doorbell Type Wireless
Number of Push Buttons 1
Included Hardware (2) #4 x ¾ in. Screws, (1) 18x31mm Adhesive Sticker, (1) #6 x ¾ in. Screw, and (1) Wall Anchor
Finished Product Dimensions 4.79 in. Height x 2.75 in. Width x 1.03 in. Depth
Transmission Range 100 ft.
Number of Sounds 2
Chime Power Source (3) AA Batteries (not included)
Push Button Power Source CR2032 Battery (included)
Troubleshooting
Problem
Possible Cause Solution
Chime does not sound when push button is pressed.
Push button battery has not been
activated.
Conrm the activation tab has been removed and
the battery is seated properly in the button.
The chime and push button are out
of transmission range.
Move the chime closer to the push button
location. Ensure there are no metallic objects or
concrete walls hindering the signal.
Push button battery needs to be
replaced.
Replace the push button battery with a CR2032
Lithium Coin battery.
Chime batteries need to be
replaced.
Replace the chime batteries with (3) AA batteries.
Chime is sounding without the push button being pushed.
An outside signal is interfering with
the signal between the chime and
push button.
Resync the chime and push button following the
steps in the instructions.
Warranty
WHAT IS COVERED
The Warrantor is pleased to extend this Warranty to you, the original consumer/end user (“Consumer”) of the doorbell products and listed by model
number below (“Doorbell Product”). This Warranty is valid for any Doorbell Product used in standard residential applications, and may not be assigned or
transferred by you.
For a period of one (1) year from the date of purchase, Warrantor, at its sole option, will repair, replace or refund the purchase price for any Doorbell Product
used in a standard residential application that malfunctions due to factory defective parts or defective workmanship in the manufacture or assembly of the
Doorbell Product.
216600Inst.ai
Learning
mode
button