User's Manual

HOMEDEPOT.COM
Please contact 1-855-556-1852 for further assistance.
5
MOUNTING THE PUSH BUTTON
□ Remove the front cover from the base by following step 1.
□ Mount the push button base to a clean wall or door jamb
with included #4 screws or mounting tape. If mounting with
screws, predrill a pilot hole through the push button base in
the desired location using a 5/64 in. drill bit.
□ Snap the push button cover onto the base by first hooking
the tops together, then snapping the base on.
6
RESYNCING THE CHIME AND PUSH BUTTON
□ Press and hold the learning mode button on the chime until
you hear a ding sound. The chime is now reset and ready to
be resynced.
□ Follow step 3 to sync the chime and push button.
Safety Information
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
could void your authority to operate the equipment.
This Device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Battery Safe Handling:
□ Do Not Mix Old And New Batteries.
□ Do Not Mix Alkaline, Standard (Carbon – Zinc), or Rechargeable (Nickel – Cadmium) Batteries.
□ Battery must be recycled or disposed of properly.
□ Keep battery away from children. If swallowed, promptly see a doctor. Do not open battery, dispose of
in fire, put in backwards, or short circuit—it may ignite, explode, leak or get hot causing injury.
Specifications
Doorbell Type Wireless
Number of Push Buttons 1
Included Hardware (2) #4 x ¾ in. Screws, (1) 18x31mm Adhesive Sticker, (1) #6 x ¾ in. Screw, and (1) Wall Anchor
Finished Product Dimensions 4.79 in. Height x 2.75 in. Width x 1.03 in. Depth
Transmission Range 100 ft.
Number of Sounds 2
Chime Power Source (3) AA Batteries (not included)
Push Button Power Source CR2032 Battery (included)
Troubleshooting
Problem Possible Cause Solution
Chime does not sound when push button is pressed. Push button battery has not been
activated.
Confirm the activation tab has been removed and
the battery is seated properly in the button.
The chime and push button are out
of transmission range.
Move the chime closer to the push button
location. Ensure there are no metallic objects or
concrete walls hindering the signal.
Push button battery needs to be
replaced.
Replace the push button battery with a CR2032
Lithium Coin battery.
Chime batteries need to be
replaced.
Replace the chime batteries with (3) AA batteries.
Chime is sounding without the push button being pushed. An outside signal is interfering with
the signal between the chime and
push button.
Resync the chime and push button following the
steps in the instructions.
WARNING: Keep batteries out of reach of
children.