User's Manual

FCC ID:

2ALCFXO-9913

In the Box

 Wireless Charging Alarm Clock (x1)

 User Manual (x1)

 Type C USB Charging Cable (x1)

Clock Setup:

Insert the small connector of the included USB power cable into the power input on the back of

the clock.Insert the large connector into the USB port on a computer or into a compatible 5V/2A

USB power adapter(not include) and plug into a wall outlet.

The clock display will turn on when the clock is connected to power.

1. Default time display 12-Hour, press and hold the [ DOWN] button to toggle between the

12-hour and the 24-hour clock.

2. Default temperature display Fahrenheit (℉ ), press [ UP ] and [ DOWN ] buttons at the same

time to toggle between Fahrenheit(℉ )and Celcius (°C )

3. In time mode ,short press [ UP ] button to switch display mode, dP-1、dP-2、dP-3 .

4. In time mode,press [ UP ] button 2 seconds enter power saving setting mode, display”--Sd”

means power saving mode in off status ; short press [ DOWN ] button ,display”“onSd” means

power saving mode on.In power saving mode,the LED display will off after 10 seconds, press any

button or tap the product to turn on the LED display. Short press [ DOWN ] button again to turn

off the power saving mode, press [ SET ] or[ UP ] will return to its default display mode.

5. In time mode,short press [DOWN] button to adjust LED display brightness, low

brightness,medium brightness,high brightness.

Setting the time:

1. Press the [ SET ]button until the time is displayed.

2. Press+hold the [ SET ]button to set the time. The time hours will begin flashing. Press the [ UP ]

and [ DOWN ] buttons to adjust. The dot in the upper left corner of the display will appear when

the hour is in PM.

3. Press [ SET ]to save the hour setting. The minute digits will begin flashing.Press the [ UP ] and

[ DOWN ] buttons to adjust,and press [ SET ] to save.The clock will return to its default display

mode.

Alarm time Function:

1. In time mode, short press [ SET ]button enter alarm mode, display “-- --” means alarm in off

PAGE 1
FCC ID: 2ALCFXO-9913 In the Box  Wireless Charging Alarm Clock (x1)  User Manual (x1)  Type C USB Charging Cable (x1) Clock Setup: Insert the small connector of the included USB power cable into the power input on the back of the clock.Insert the large connector into the USB port on a computer or into a compatible 5V/2A USB power adapter(not include) and plug into a wall outlet. The clock display will turn on when the clock is connected to power. 1.
PAGE 2
status. 2. Press [ UP ] or [ DOWN] to turn on the alarm function, 12-Hours default,the dot in the lower left corner will display when the alarm is turned on. 3. When the alarm is turned on ,press+hold the [ SET ] button to set the alarm time.The alarm hours will begin flashing Press the [ UP] and[ DOWN ] button to adjust. 4. Press [ SET ]to save the alarm hour setting . The alarm minute digits will begin flashing .Press the [ UP ] and [ DOWN ] buttons to adjust ,and press [ SET ] to save.
PAGE 3
FCC Statement This device complies with part 15 and part 18 of the FCC Rules. Operation is Subject To the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not explicitly approved by the party responsible for compliance could void the user's authority to operate this equipment.