Installation Instructions

Bluetooth Speaker
AAA battery
-4 hours
Battery:AAA battery x 3
Dimension: 70 x 70 x 41.5mm
200HZ-20KHZ
FCC ID: 2ALCFXO-9227
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This device complies with Part
15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
RF Exposure Warning Statements:
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure
condition without restriction.
Please remove the battery isolator the rst time you
use the speaker.
When replacing the speaker's batteries,
make sure to properly dispose of the
unwanted batteries.
Use 3 x AAA batteries to replace the existing
batteries, and place the new batteries in the
direction the + or position.
1. Turn the power switch to turn on the Bluetooth
Speaker
. A prompt will sound.
Bluetooth Function:
2. On your mobile device, turn Bluetooth on, search
f
or Bluetooth devices, and select ”Whammo”.
Made In China