User's Manual

802.11n, MIMO 64 QAM 5/6 26.84 -72
2.4 GHz (40 MHz Channel)
802.11n, MIMO BPSK 1/2 26.94 -90
802.11n, MIMO 16 QAM 3/4 26.94 -79
802.11n, MIMO 64 QAM 5/6 26.94 -70
Note 1 It is advantageous to use the smallest Channel Bandwidth that can support the Throughput
requirements. Smaller bandwidths provide more channels to choose and help avoid interference
issues. The system’s SNR is higher at smaller Channel Bandwidths and Range is longer.
Note 2 Max allowed Tx power depends on the regulatory domain
Antenna Signal Strength -35 to -85 dBm (Recommended), Absolute Maximum=+12 dBm
Antenna port isolation for
concurrent operation
Up to +10 dBm signal strength for 5 GHz signal without degrading 2.4
GHz operation
Up to +5 dBm signal strength for 2.4 GHz signal without degrading 5.x
GHz operation
Integrated Antenna Port
Protection
>20 KV (Human Body Model)
Receiver LNA Gain >10 dB
Receiver Adjacent Channel
Rejection (ACR)
>18 dB @ 11a, 6 Mbps (Typ)
Receiver Alternate Channel
Rejection (ALCR)
>35 dB @ 11a, 6 Mbps (Typ)
Receive chain Noise Figure +6 dB
Transmitter Adjacent Channel
Leakage power Ratio (ACLR)
45 dB (Fc ± ChBW)
Transmitter Spurious
Emission Suppression
-40 dBc
RF Power control
In 0.5 dBm steps. Accuracy of power calibration loop ±2 dBm. Each
transceiver individually calibrated and tested.
RF Hardware Disable (RF
Kill)
Pin 20 of miniPCI-E interface. (Required for FAA compliance)
Control for External Power
Amp
Available as an optional configuration
Spectral Analysis 8 bit resolution spectral FFTs available for software analysis
PHYSICAL, ENVIRONMENTAL AND OTHER SPECIFICATIONS
Antenna Ports 3 Ports (50 Ohms) with MMCX connectors.
Host Interface miniPCI-Express 1.2 Standard
Host CPU Board
Any CPU board with Industry standard miniPCI-Express interface with
minimum 6 mm connector height
Operating Voltage 3.3 Volts from miniPCI-Express connector
Power Consumption
5.3W @ Max power, in continuous data transfer mode on all chains
3.75W @ 25 dBm power, in continuous data transfer mode on all
chains
2.5W @ 20 dBm power (ETSI max), in continuous data transfer mode
on all chains
0.9W in continuous data receive mode
250 mW in Sleep mode
Shield case temperature
range (Operating)
-40°C to +80°C
The System’s thermal design should ensure that the transceiver’s case
temperature is maintained within these specifications.
Humidity (Operating) 0% – 95% (Non-condensing)
Dimensions 30 x 50 x 7 mm, 14 grams