Integration Instructions

signaling amplitude, buffered modulation/data
inputs, or power supply regulation. The
alternative method could include that the
limited module manufacturer reviews detailed
test data or host designs prior to giving the host
manufacturer approval.
This limited module procedure is also
applicable for RF exposure evaluation when it
is necessary to demonstrate compliance in a
specific host. The module manufacturer must
state how control of the product into which the
modular transmitter will be installed will be
maintained such that full compliance of the
product is always ensured. For additional hosts
other than the specific host o riginally granted
with a limited module, a Class II permissive
change is required on the module grant to
register the additional host as a specific host
also approved with the module.
2.5 Trace antenna designs
For a modular transmitter with trace antenna
designs, see the guidance in Question 11 of
KDB Publication 996369 D02 FAQ – Modules
for Micro‐Strip Antennas and traces. The
integration information shall include for the
TCB review the integration instructions for the
following aspects: layout of trace design, parts
list (BOM), antenna, connectors, and isolation
requirements.
4
a) Information that i ncludes permitted
variances (e.g., trace boundary limits,
thickness, length, width, shape(s), dielectric
constant, and impedance as applicable for each
type of antenna);
b) Each design shall be considered a
different type (e.g., antenna length in
multiple(s) of frequency, the wavelength, and
antenna shape (traces in phase) can affect
antenna gain and must be considered);
c) The parameters shall be provided in
a manner permitting host manufacturers to
design the printed circuit (PC) board layout;
d) Appropriate parts by manufacturer
and specifications;
e) Test procedures for design
verification; and
Yes The module has its own fixed antenna path