User Manual

)&&&RPSOLDQFH1RWLFH
Specific Absorption Rate (SAR) information SAR tests are conducted using
standard operating positions accepted by the FCC with the phone
transmitting at its highest certified power level in all tested frequency bands,
although the SAR is determined at the highest certified power level, the
actual SAR level of the phone while operating can be well below the
maximum value, in general, the closer you are to a wireless base station
antenna, the lower the power output.
Before a new model phone is a available for sale to the public, it must be
tested and certified to the FCC that it does not exceed the exposure limit
established by the FCC, Tests for each phone are performed in positions
and locations (e.g. at the ear and worn on the body)as required by the FCC.
For body worn operation, this mobile phone has been tested and meets the
FCC RF exposure guidelines when used with an accessory designated for
this product or when used with an accessory that contains no metal and that
positions the handset a minimum of 1cm from the body.
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
08
Certification Information
Disclaimer
This user guide is published by DOOGEE or its local affiliated company.
Improvements and changes to this user guide necessitated by typographical
errors, inaccuracies of current information, or improvements to programs and/or
equipment, may be made by DOOGEE at any time and without notice. Such
changes will, however, be incorporated into new online editions of the user guide (
please see details at www.doogee.cc/page/manual.html ). All illustrations are for
illustration purposes only and may not accurately depict the actual device.
(Highest SAR)
SAR 1g limit: 1. W/Kg,
SAR Value:Head:0.1W/Kg,Body:0.85W/Kg(10mm distance).