Instructions

ENGLISH

Do not expose the device to direct sunlight. The housing temperature

can exceed the maximum allowed temperature limit. This can result

in damage of electric and mechanic components of the device and

injuries especially when touching exterior parts of the device. White

and bright silver-colored front plates absorb less sunlight than dark

ones.

An image sensor must not be exposed to direct sunlight for an

extended period of time. Direct sunlight will “blind” the camera

and may permanently bleach the small color filters on the image

sensor chip.

Any defects caused by direct sunlight is not covered by warranty.

STEP 4: POWER SUPPLY

The video door station can be powered by two simple doorbell wires using

the power-supply unit (mains adaptor) supplied with it or via PoE (Power

over Ethernet) using a network cable. The video door station can alternatively

also be supplied with a DIN-rail power supply unit that you can obtain from

us directly.

The video door station does not use battery power. The use of a mains power

supply permits the transmission and display of on-demand live video at any

time and not only if a visitor has pressed the doorbell.

Power supply using the power-supply unit (mains adaptor)

Two insulated wires are required to power the video door station by plugging

it into the mains. These wires are normally already there and are freely

accessible once you have removed the previous doorbell. Only use the power

supply unit provided along with the video door station, or a DIN-rail power

supply unit that you can obtain from us separately, since this has been spe-

cially stabilized electrically and is equipped with an integrated audio interfe-

rence reduction device. Other power supply units may destroy the video door

station or cause poor transmission quality. The warranty automatically expi-

res if you use a different power supply unit. The power supply unit is plugged

into a wall socket inside your house, usually where the two wires from your

previous doorbell come out of the wall in the interior of the house.

Do not plug the power supply unit into the wall socket yet. Connect the po-

wer supply unit inside the house with the crimp connector provided and the

two wires that you would like to use to power the device.

NOTICE