Manual

Page 38 1810-162-J-1-12
2.4.1 Single or Multiple Units
Default setting is 1 (Single Unit).
Set for single if only one Access Plus unit is connected to the phone line, or set to multiple if more
than one Access Plus units are connected to the phone line.
1. Press * 6 1 and then enter the MASTER CODE. [ * 6 1 _ _ _ _ (beep)]
2.
Press 1 * for a single system OR press 0 * for multiple systems. [ _ * (beep)]
3.
Press 0# TOGETHER to end. [0# (beeeeeep)]
2.4.2 Single or Double Ring
Default setting is 1 (Double Ring).
The Access Plus unit can be used in both an auto-dialer and/or telephone intercom
configur
ation. When used as an auto-dialer, the double ring programming has no affect on
the ring – this is controlled by the phone company and it will always be the standard single
ring no matter how the ring is programmed in the Access Plus unit.
In the telephone intercom mode connected to th
e 1816 AP module, the double ring provides a
unique ring so that a call from the Access Plus unit is easily identified by the resident.
1. Press * 6 3 and then enter the MASTER CODE. [ * 6 3 _ _ _ _ (beep)]
2.
Press 1 * for a double ring OR press 0 * for a single ring. [ _ * (beep)]
3.
Press 0# TOGETHER to end. [0# (beeeeeep)]