Manual

1810-162-J-1-12 Page 55

4.2 Remote Operation

4.2.1 Remote Programming

The Access Plus unit can be programmed and operated from a remote location using a touch-tone

telephone. Be sure that the ability for the unit to answer an incoming call has not been disabled (see

2.4.7).

Note: The Access Plus unit master code cannot be programmed remotely – it can only be

programmed from the system keypad – see Programming the Master Code on page 32.

1. Call the unit’s phone number. After the programmed number of rings (2.4.7) the Access Plus

unit will answer with a tone.

2. Follow the desired programming steps in Section 2 of this manual.

3. When complete with the desired programming function, hang up. You cannot use 0# to end

programming steps from a touch-tone telephone.

4.2.2 Remote Relay Activation

The Access Plus system relays can be activated from a remote (off site) location. Be sure that the

ability for the Access Plus unit to answer an incoming call has not been disabled (see 2.4.7). Refer to

the tone open numbers that where programmed in section 2.4.6 to determine each of the activation

numbers.

 Momentary Activation (Relay activates for its programmed strike time)

 Hold Open (Relay will activate and remain activated).

 Deactivate (Relay will deactivate)

 Hold 1 Hour (Relay will activate for 1 hour and then automatically deactivate)

To activate the relay(s) from a remote (off-site) location, perform the following steps.

1. Call the phone number that the Access Plus unit is connected to. After the programmed

number of rings (2.4.7) the unit will answer with a tone.

2. Press * 1 6 and enter the MASTER CODE. [ * 1 6 _ _ _ _ (beep)]

(Two-way voice communication is also enabled at this point)

Enter the desired tone open number. [ _ (beep)]

4. Han

g up.