Owner`s manual

3.2 Programming with a PC

Prior to programming the PC Programmable Telephone Entry System with the DoorKing Remote

Account Manager for Windows software and the user supplied PC, the system must have the

MASTER CODE programmed into it. The master code cannot be set with the PC and must be

programmed from the system keypad.

This telephone entry system has a programming function that is used in special circumstances when

interfaced with a DoorKing 1816 Telephone Intercom System. This CALL UP feature provides

special programming that will allow the system to call the phone number of a CO line connected to

the 1816 system. Once the 1816 answers the call, the system will automatically send out DTMF

tones that will activate the CALL UP feature in the 1816 system, and then send the four digit directory

code to the resident selected by the visitor. This allows visitors to contact tenants in the building that

do not have CO phone service through the telephone entry system. This feature IS NOT

programmable from the software and must be turned ON or OFF at the system keypad (3.2.2).

3.2.1 Master Code

This programming step sets the system MASTER CODE. The master code is the four-digit number

required to gain access to the system memory. You need to know the master code prior to

programming the system with the PC, or to perform any of the programming functions on the

following pages.

NOTE: The master code cannot be programmed from an off-site location. The master code

can only be programmed from the system keypad.

Factory setting = 9999

1. Open the cabinet of the telephone entry system and turn the master code switch (the

small toggle switch) on.

2. Enter a four-digit master code _ _ _ _ then press * (beep).

3. Turn the master code switch off and close the cabinet.

3.2.2 Programming for Call-up Operation

This feature is only used when the telephone entry system is interfaced with a DoorKing 1816

Telephone Intercom system under certain special applications. The factory setting for this feature is

OFF. Do not change this feature to ON. Refer to the 1816 Installation Manual, and check with your

DoorKing representative on the special applications that this feature is used for.

Factory Setting = OFF

1. Press *78 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Enter 0* (beep) to turn the call up feature OFF.

Enter 1* (beep) to turn call up ON.

3. Press 0# TOGETHER to end this programming step (beeeeeep).