Owner`s manual

9210-065-H-2-13

1.2 Underground Conduit Requirements

Primary/Secondary Interconnection Cable (Dual Operator Application Only)

Sweeps

Concrete Pad

3/4 Inch Minimum

Single/

Primary

Operator

Position

Secondary

Operator

Position

SECTION 1 - INSTALLATION

Prior to beginning the installation of the slide gate operator, we suggest that you become familiar with the

instructions, illustrations, and wiring guide-lines in this manual. This will help insure that your installation is

performed in an efficient and professional manner compliant with UL 325 safety and ASTM F2200 construction

standards.

The proper installation of the vehicular slide gate operator is an extremely important and integral part of the

overall access control system. Check all local building ordinances and building codes prior to installing this

operator. Be sure your installation is in compliance with local codes.

1.1 Gate Hardware

DoorKing has a full line of Tandem V-wheels that are ideal for heavy gates and

will ensure safe, reliable and long lasting gate operation. The gate must be

properly installed and roll smoothly in both directions.

Guide Rollers with Protective Covers

Helps to minimize a pinch point on the

gate.

4 Inch6 Inch

• The conduit requirements are for a typical slide gate operator installation (the secondary operator is shown for

those applications where a secondary operator may be used). The conduit requirements for your application may

vary from this depending on your specific needs.

• Use only sweeps for conduit bends. Do not use 90° elbows as this will make wire pulls very difficult and can cause

damage to wire insulation.

• DoorKing recommends using 3/4-inch conduit.

• Be sure that all conduits are installed in accordance with local codes.

• Never run low voltage rated wire insulation in the same conduit as high voltage rated wire insulation.

Elbow

Sweep

YES

Control and/or P.A.M.S. Wires (Low Voltage wire insulation)

Loop Lead-In Wires (Low Voltage wire insulation)

AC Input Power (High Voltage wire insulation)