Owner`s manual
9510-065-L-3-13
20
TIME
DELAY
EXIT
LOOP
LMT
LMT
REVERSE
LOOP
REV SENSE
OPEN
REV SENSE
CLOSE
1
ON
2 3 41
ON
2 3 4 5 6 7 8
NC
NO
P8
P7P6
4404-010
20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4321
Limit Nut
A
A1
C1
B
C
Limit LEDs
C
C
C
C
L
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
C
A
A
A
A
A
A
A
A
A
A
A
MT
T
T
T
T
T
T
T
T
C
C
L
C
L
L
L
T
C
L
L
L
L
L
T
L
L
L
L
L
L
T
L
L
L
L
L
L
L
T
L
L
L
L
L
LMT
T
L
L
L
L
LMT
T
L
L
LMT
T
L
LMT
T
Note: If limit
plug is not
connected to
the circuit
board and
AC power is
turned on,
alarm will
sound and
operator will
NOT
function.
Main Terminal Partial Open Connection
Push
Push
L
ock-Plate
Limit Nut
Limit Nut
A
B
C
A
C
C
C
C
Partial Open Adjustment Rail
Slow-Down Limit
Slow-Down Limit
A1
C1
3.3 Limit Switches
Middle Limit Nut (Partial Open)
Magnet - Align with magnetic pick-up sensor
Slow-Down
Limit
(3/4 inch
adjustment
ONLY)
Slow-Down
Limit
(3/4 inch
adjustment
ONLY)
Partial Open
Magnetic
Pick-up
Sensor
Adjustment
Limit
Switch
Magnetic Pick-Up Sensor
Limit
Switch
A
C
A1
C1
B
Adjust Limit Nuts
Important: Turn power OFF and set AC module to
maximum speed before adjusting limit nuts!
Push and hold the lock plate down where shown to adjust the
Open and Close limit nuts.
After adjusting the limit nuts, be sure that the lock-plate is
engaged in the slots on the limit nuts to prevent them from
rotating.
The slow-down limit assembly will move up or down 3/4 inch.
DO NOT remove the slow-down limit assembly from the 3/4
inch slot and re-attach it in the partial open adjustment rail to
gain further adjustment. This will cause mechanical damage
to the switch assembly when the operator is activated.
Turn power on and activate the gate operator.
Re-adjust the limit nuts as necessary for full-open and
full-close gate travel. After you are satisified with the gate
limit settings, the AC module can then be adjusted to personal
preference (See page 22).
1
2
4
5
3
Partial Open Feature:
When
using the partial open feature, the
operator’s access control device must
be connected to terminal #5 .
Adjust the middle limit nut and
magnetic pick-up sensor assembly to
the gate’s desired stopping position.
Be sure to align the magnet (Recessed
in the limit nut) with the magnetic
pick-up sensor.
Check the polarity: Position the gate half way open. Give open command
and while gate is opening, activate the appropriate limit switch with your
finger. Gate should STOP. If it does not, activate the other limit switch. If
this STOPS the gate, AC power wires must be changed (Reverse the
connection of any 2 wires and re-check limits).