Owner`s manual

9510-065-L-3-13
24
TIME DELAY
EXIT LOOP
LMT
LMT
REVERSE LOOP
REV SENSE
OPEN
REV SENSE CLOSE
1
ON
2 3 41
ON
2 3 4 5 6 7 8
NC
NO
P8
P7P6
4404-101
20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 54321
Gate Frame Gate Frame
5”
or
Less
5”
or
Less
Non-Secure Side
Outside Property
Secure Side
Inside Property
Filler Post or Barrier
Reversing Edge (Open Contact Sensor)
4.2 Secondary Entrapment Protection Device Locations
Photo Sensors (With Filler Post and Reverse Edge) Sample Setup
Typical UL Photo Sensor mounting height
and distance away from gate.
Photo sensors may be installed on either side of gate frame, as close
as practical to the gate but no further away than 5”.
No higher than
27.5” above grade.
21” is typical for
most installations.
Note: Additional
photo sensors can
be added above
the 27.5” height.
If the distance between the gate
and wall is greater than 2 1/4”.
Wall
Sensor mounted on post.
Sensor mounted on wall.
Closed Gate
Wall
Normally Open
Normally Open
Normally Open
Common
Common
Common
Common
Normally Open
A filler post or barrier may need to be installed between the
gate and wall area to reduce the distance to 2 1/4” or less.
A reversing edge should be installed on the post or barrier
for safety (See pages 4 and 5 for more information).
Photo Sensor Power Note: Photo sensors can be powered by the built-in
convenience outlets located on the operator (See previous page).
Closing-direction photo sensors wired to UL 325 terminal.
Closing-Direction Photo Beam
Opening-Direction Photo Beam
6-Pin
UL 325
Terminal
Wiring
“Reverse” Closing-Direction Option
Filler Post with Opening-Direction Reversing Edge (If necessary, see above)
OPEN Entrapment Sensor
CLOSE Entrapment Sensor
OPEN Contact Sensor
CLOSE Contact Sensor
Low Voltage Common Low Voltage Common
SW 1, switch 7
MUST be OFF.
IF the closing-direction photo sensor is wired to the UL 325 terminal, a
closing-direction photo beam that gets obstructed will STOP the gate, then
resume closing the gate when the obstructed photo beam has been cleared.
IF the closing-direction photo sensor is wired to the #6 main
terminal, a closing-direction photo beam that gets
obstructed will REVERSE the gate back to the open position.
1
ON
2 3 4 5 6 7 8
SW 1 is Upside-Down on Board
123456
WARNING
MOVING GATE CAN CAUSE
Operate gate only when gate area is in sight and free of people and obstructions. D
o not allow children to play in gate area
or operate gate. Do not stand in gate path or walk through path while gate is moving. Read owner’s manual and safety instructions.
SERIOUS INJURY OR DEATH