Operation and maintenance manual

DX140R/DX140LCROperating Controls
2-14
13. Wiper Switch Panel
This panel is only for operation of the upper windshield
wiper. When the wiper stops running, it moves to right side
of the cabin, resting in its support.
NOTE: When
the front window is lifted, the wiper motor
will not operate.
Constant Speed Button
Pressing the button turns "ON"
the windshield wiper. An
indicator light above the button will turn "ON" indicating
that wiper is "ON". The wiper will run at a constant speed.
Pressing the button again, turns "OFF" the windshield
wip
er.
Intermittent Speed Button
Pressing button once (first time):
Windshield wiper runs approximately on a three second
intermittent cycle.
The left side indicator light will turn "ON".
Pressing button again (second time):
Windshield wiper runs approximately on a six second
intermittent cycle. The right
side indicator light will turn
"ON".
Pressing button again (third time):
Turns "OFF" the windshield wiper. Both indicator lights
will
be turned "OFF".
Windshield Washer Button
Pressing the washer button will spray windshield washer
f
luid onto the windshield. Use only the proper windshield
washer fluid in the system.
NOTE: Do not operate the windshield washer without
any fluid. If operate without any fluid, the
washer motor may be damaged. Check level in
washer tank, and add fluid as required.
NOTE: Using soapy water or synthetic detergent
instead of window cleaning fluid, can damage
the wiper blade or painted surfaces. Use
standard window cleaning fluid: SSK703.
FG000308
Figure 20
FG000241
Figure 21
FG000242
Figure 22
FG000243
Figure 23