Operation and maintenance manual

DX140R/DX140LCROperating Controls
2-16
17. Travel/Swing Alarm Switch (Optional)
If unit is equipped with a travel/swing alarm buzzer, push
this switch to active it, whenever swinging or traveling.
O. In this position, the travel/
swing alarm system is
turned "OFF".
I. In this position, the travel
alarm will only sound, when
the machine is moving.
II. In this position, the travel/swing alarm will sound
wh
ile swinging and traveling, if equipped with a swing
alarm device.
NOTE: If machine
is only equipped with a travel
alarm device, the alarm will not sound
when swinging although the switch is in
the "II" position.
18. Horn Button (Left-hand Work Lever)
Press the lower button on the top of the left-hand work
lever (joystick) to sound horn.
NOTE: The starter swit
ch must be "ON".
19. Rotating Buttons
For a machine equipped with an attachment that rotates,
press the upper two buttons on the top of the left-hand
work lever (joystick) to rotate the attachment clockwise or
counterclockwise. Left button is for counterclockwise and
the right one is for clockwise.
FG000031
O
I
II
Figure 27
FG014541
Figure 28
FG014542
2
1
Figure 29
CAUTION
AVOID INJURY
Before using any attachment in a work application, be
sure
to check its functional control. Make sure that
desired movement or action is being activated by the
control. e.g. opening/closing, CW/CCW, crowd/dump,
etc.