Operation and maintenance manual

DX140R/DX140LCROperation
3-4
Engine Start
1. Perform all steps in "Operational Checks Before Starting
Engine" on page 3-3.
2. Set engine speed control dial slightly above
"LOW IDLE"
(Figure 3).
3. Sound horn.
4. Enter password.
NOTE: If
the security system is "LOCKED", a four-digit
password will be required to start the engine. If the
system is "UNLOCKED", no password will be
required and this display screen will not appear.
5. Turn starter switch to (START) position (Figure 5).
Engine should start in approximately five seconds.
6. After engine has started, release key.
Key will return to "I"
(ON) position (Figure 5).
7. Follow procedures in "Hydraulic System Warm-up" on
page 3-9.
WARNING
AVOID DEATH OR SERIOUS INJURY
Start the engine after sounding horn and making sure there
are n
o people or obstacles in the area.
HAOB34L
Figure 3
FG013717
ENTER
PASSWORD
Figure 4
FG000085
O
I
Figure 5
WARNING
AVOID DEATH OR SERIOUS INJURY
If the engine does not start after approximately fifteen
seconds
of cranking, release the starter switch. Wait
about five minutes and repeat above step.
""