Operation and maintenance manual

Operation
3-7
DX140R/DX140LCR
5. After the preheat completion, immediately turn starter
switch to (START) position (Figure 10). Engine
should start in approximately five seconds.
6. After engine has started, release key.
Key will return to "I"
(ON) position (Figure 10).
7. After the engine starts, check all operating indicators to
make sure that all engine systems (oil
pressure, coolant,
etc.) are in the normal operating range. If any problems are
noticed, stop engine.
8. Follow "Hydraulic System Warm-up" procedures in this
section. (See page 3-9)
Starting Engine With a Booster Cable
FG000085
O
I
Figure 10
WARNING
AVOID DEATH OR SERIOUS INJURY
If the engine does not start after approximately fifteen
seconds
of cranking, release the starter switch. Wait
about five minutes and repeat above step.
""
HAOA440L
Figure 11
WARNING
AVOID DEATH OR SERIOUS INJURY
1. An explosive gas is produced while batteries are in
use or
being charged. Keep flames or sparks away
from the battery area.
2. Charge batteries in a well ventilated area.
3. Always wear eye protection when starting a machine
wi
th jumper cables.
4. Improper jump starting procedures can cause an
explo
sion resulting in personal injury.
5. Jump start vehicles on dry ground or concrete. Do not
jump
start the machine on a steel floor, because the
floor is always grounded.
6. When starting from another machine, make sure the
machine
s do not touch.
7. Always connect the auxiliary battery positive (+)
termin
al too depleted battery positive (+) terminal first.
Then connect auxiliary battery negative (-) terminal to
the frame of the depleted battery machine second.
8. Connect positive cable first when installing cables and
disconnec
t the negative cable first when removing.