Operation and maintenance manual

DX140R/DX140LCROperation
3-12
5. Stop engine by turning key to "O" (OFF) position (Figure
24).
6. Remove key from starter switch.
Check and Confirmation After Stopping
Engine
1. Repair excavator, if there are any coolant or oil leaks.
2. Inspect front attachment and under carriage for abnormal
appea
rances. Correct any problems.
3. Fill fuel tank.
4. Get rid of any accumulated flammable materials such as
leaves
and paper etc. in engine compartment.
5. Clean all mud, etc. from undercarriage and tracks. Make
sure
that all steps and hand holds are clean, and that
operator's cabin is clean.
SAFETY LEVER
Be careful not to move the work levers (joysticks) when moving
safety lever.
FG000175
O
I
Figure 24
WARNING
AVOID DEATH OR SERIOUS INJURY
When stopping engine or leaving the operator's seat,
"LOCK" the sa
fety lever, otherwise, a serious accident can
occur by accidental movement of travel and work levers.
Whenever leaving the operator's seat, make sure the engine
is
stopped and the safety lever is "LOCKED".
Especially, when adjusting the seat, control stands, or
raising the
front window, lower window, or ceiling cover,
never forget to lock the safety lever in its "LOCKED"
position.