Operation and maintenance manual

DX140R/DX140LCROperation
3-30
Working in Water
When working in water, do not operate in water over center of
upper roller (1, Figure 70).
If swing bearing gets wet, immedi
ately grease it until all old
grease is purged from bearing.
If water gets into swing gear housing, drain water immediately
by r
emoving lower inspection cover. Apply new grease.
After working in water, purge old grease on bucket pins.
FG000179
Figure 69
IMPORTANT
When working in water, do not exceed a slope of more than
15°. If the slope is over 15°, the rear part of the upper
structure will be immersed in water, resulting in radiator fan
and engine ECU damage.
FG000181
1
Figure 70