Operation and maintenance manual

Operation
3-43
DX140R/DX140LCR
OPERATION UNDER UNUSUAL
CONDITIONS
NOTE: See "Maintenance in Special Conditions" on
page 4-84 for other recommendations.
Operation In Extreme Cold
If machine is to be operated in extreme cold weather
temperatures, certain precautions must be taken to assure
continued normal operation. The following paragraphs detail
checks to be made to be certain the machine is capable of
operating at these temperatures.
1. Check the cooling system for correct antifreeze solution for
lowest te
mperature expected. Carefully inspect cooling
system and correct or report any leaks.
2. Keep batteries fully charged to prevent freezing. If water is
added
to batteries, run engine at least one hour to mix
electrolyte solution.
3. Keep engine in best possible mechanical condition to
assure
easy starting and good performance during
adverse weather.
4. Use engine oil of the proper specificat
ions for the expected
temperatures. Refer to "Lubrication Specifications" of the
engine manual for details.
5. Keep fuel tank full at all times. Dr
ain condensation from
tank before and after operation. Drain and service fuel
filter. To eliminate clogging of fuel filters because of wax
crystal formation in the fuel, be sure that the fuel used has
a cloud point specification below the lowest expected
temperature.
6. Lubricate entire machine according to "Periodic Service
Tab
l
e and Chart" Section 4, in this manual or lubrication
chart on machine.
7. Start engine and allow it to reach normal operating
te
mperature before applying load.
A. If mud and ice collects and freezes on any of the
moving parts while
machine is idle, apply heat to
thaw the frozen material before attempting to operate
machine.
B. Operate hydraulic units with care until they have
reached
a temperature to enable them to operate
normally.
C. Check all machine controls and/or functions to be
sure
they are operating correctly.
8. An extra outer air filter must be kept in the operator's cabin
to re
place element that could become iced and cause
restricted air flow to engine.