Operation and maintenance manual

DX140R/DX140LCRTransportation
5-6
LIFTING MACHINE
1. Refer to "Specification" section of this manual for weight
and dimensional information.
2. Lower the work equipment to the ground as shown in the
diagra
m on the right
3. Lower the dozer blade to the ground. (if equipped)
4. Move safety lever to "LOCK" position. Stop engine.
5. Ensure that there is nothing around the operator's
co
mpa
rtment, close the cab door and front glass securely.
6. Bind wire ropes between the 1st and 2nd track rollers from
the fro
nt and between the 1st and 2nd track rollers from the
rear.
7. Use spreader bars between the wire rope and the machine
to pr
event damage to the rope or machine. Set the lifting
angle (1, Figure 12) of the wire rope to 30° - 40°.
8. After the machine comes off the ground, check the hook
cond
ition and the lifting posture, and then lift slowly.
EX1300819
1
1
Figure 12
WARNING
AVOID DEATH OR SERIOUS INJURY
Never lift the machine with a person in the cabin or on the
machine
.
Never enter the area under or around a raised machine.
Improper lifting can allow load to shift and cause death or
serio
us injury or property damage.
When lifting, move the safety lever to "LOCK" position to
prevent
the machine from moving unexpectedly.
Use only properly rated cables and slings
Never go in the area under or around the machine when it is
raised.
Always use the posture given in the procedure below and
use
the proper lifting equipment to lift the machine.