Operation and maintenance manual

DX140R/DX140LCRSafety
1-46
Proper Tools
Use only tools suited to the task. Using damaged, low qualify,
faulty, or makeshift tools could cause personal injury. There is a
danger that pieces from, chisels with crushed heads, or
hammers, may get into your eyes and cause blindness.
Use of Lighting
When checking fuel, oil, battery electrolyte, or window washing
fluid, always use lighting with antiexplosion specifications. If
such lighting equipment is not used, there is a danger of an
explosion.
If work is carried out in dark places without using lighting, it may
lead to
injury, so always use proper lighting.
Even if the place is dark, never us
e a lighter or flame instead of
lighting. There is a danger of fire. There is also a danger that
battery gas may catch fire and cause an explosion.
Fire Prevention and Explosion Prevention
All fuels, most lubricants and some coolant mixtures are
flammable. Leaking fuel or fuel that is spilled onto hot surfaces
or onto electrical components can cause a fire.
Store all fuels and all lubricants in properly marked containers
and away
from all unauthorized persons.
Store oily rags and other flammable material in a protective
contain
er.
Do not smoke while you refuel the machine or while you are in a
re
fueling area.
Do not smoke in battery charging areas or in areas that contain
flamma
ble material.
Clean all electrical connections and tig
hten all electrical
connections. Check the electrical wires daily for wires that are
loose or frayed. Tighten all lose electrical wires before you
operate the machine. Repair all frayed electrical wires before
you operate the machine.
Remove all flammable materials before they accumulate on the
machin
e.
Do
not weld on pipes or on tubes that co
ntain flammable fluids.
Do not flame cut on pipes or on tubes that contain flammable
fluids. Before you weld on pipes or on tubes or before you flame
cut on pipes or on tubes, clean the pipes or tubes thoroughly
with a nonflammable solvent.
HDO1037L
Figure 36
HDO1040L
Figure 37
HDO1015I
Figure 38